Hopper Safety Bar; Jacking The Machine; Transporting The Machine; Towing Or Pushing A Disabled Machine - Advance CS7000 Serie Instrucciones De Uso

HOPPER SAFETY BAR

WARNING!
Make sure the Hopper Safety Bar (23) is engaged
whenever attempting to do any maintenance work
under or near the raised hopper. The Hopper Safety
Bar (23) holds the hopper in the raised position to
allow work to be performed under the hopper. See
Figure 1. NEVER rely on the machine's hydraulic
components to safely support the hopper.
A - To Engage Hopper Safety Bar:
1. Press and hold the hopper raise switch to raise the
hopper.
2. Pull the hopper safety bar handle (21) toward you to
retract the safety bar (23).
3. Press and hold the hopper lower switch to lower the
hopper until it contacts the hopper safety bar.
B - To Disengage Hopper Safety Bar:
1. Press and hold the hopper raise switch to raise the
hopper slightly so it lifts off of the hopper safety bar.
2. Push the hopper safety bar handle (21) toward the
front of the machine to extend the safety bar (23).
3. Press and hold the hopper lower switch to lower the
hopper.

JACKING THE MACHINE

CAUTION!
Never work under a machine without safety stands
or blocks to support the machine.
• When jacking the machine, do so at designated
locations (Do Not jack on the hopper) - see Jack
Point / Tie Down Point locations (33).

TRANSPORTING THE MACHINE

CAUTION!
Before transporting the machine on an open truck or
trailer, make sure that . . .
• All access doors are latched securely.
• The machine is tied down securely - see Jack Point /
Tie Down Point locations (33).
• The machine parking brake is set.

TOWING OR PUSHING A DISABLED MACHINE

CAUTION!
If the machine must be towed or pushed, make sure the Key Switch is in the Off position and do not move the machine faster than a
normal walking pace (2-3 mph, 3-5 kph) and for short distances only.
A second option which will allow for steering while pushing or towing the machine is to do the following:
-Turn the Key Switch (A) ON while pressing and holding both the Speed Switch (K) and the High Pressure Wand Switch (N) for two
seconds.
FIGURE 1
FIGURE 2
Jack Point / Tie Down Point symbol
ENGLISH / A-5
FORM NO. 56041979 - CS7000 - A-5