Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Attention: the fan can be used only when completely and correctly assembled, that is
complete with protection grids (rear and front).
Attention: always unplug the appliance before you assemble the appliance.
If in doubt, have the appliance checked or assembled by a qualified professional person.
For assembly, refer to below pictures.
Ventilator
1.
Fasten the rear grid (5) to the motor casing, positioning the corresponding pins and
holes, and lock using the appropriate ring nut (4).
2.
Insert the fan (3) on the motor shaft (6) and lock with the appropriate ring nut (2) turning
it tightly anti-clockwise.
3.
Couple the front grid (1) with the rear grid (5) and lock with the plastic ring and ensure
the fastening with the appropriate locking screw (11). Having done this, check that the
protection grid is firmly coupled and fastened to the motor.
Wall installation
• The appliance must only be used if secured to a wall: the wall must be flat, smooth, very
stable (as the appliance could tip over) and resistant.
• To install the appliance, proceed as follows and refer to the figures.
• If the appliance is fitted to a wall, the same must be made of masonry and/ or of resistant
material (not of wood or synthetic material); follow the indications below for installation:
- The wall fan must be installed at least 2 m above the floor
- Place the metal plate to the wall, make 3 holes in the wall, as far apart (before drilling holes
is good to measure the distance between the slots above), insert the screw anchors into the
holes, place the plate metal and tighten the screws, attach the motor housing to the plate
15/48
Publicidad
