Hilti NURON SL 10-22 Manual De Instrucciones Original página 16

▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
10.1 Shoulder strap
CAUTION
Inadequate fastening presents a hazard! The shoulder strap disengages and the tower light drops down.
▶ When you use the shoulder strap, make sure that it is correctly secured to the tower light.
The tower light can be transported easily and conveniently with the shoulder strap.
▶ Hook the shoulder strap into the eyelets for the shoulder strap. Check that it holds securely.
11 Troubleshooting
If a problem occurs, always observe the status indicator of the battery. See the section headed Status
indicators of the Li­ion battery → page 4.
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, contact Hilti Service.
Trouble or fault
Tower light tends to topple or
is unsteady.
LEDs of the battery show
nothing
12 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
13 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
10 English
Possible cause
Tripod legs not locked.
Tower light set up on a surface that
is not level.
Rubber feed faulty/worn.
Supply cord pulled taut.
Battery faulty.
Action to be taken
▶ The carrying handle must
engage with an audible click
when the tripod legs are
extended. → page 7
▶ Set up the tower light on a level
surface.
▶ Replace the rubber feet.
→ page 9
▶ Route the supply cord in such
a way that it does not present a
trip hazard. → page 8
▶ Route the supply cord in such a
way that it is not pulled taut.
▶ Contact Hilti Service.
2385040
*2385040*