Stahlwille MANOSKOP 714 Manual De Instrucciones página 101

Undertaking settings on the PC
 Make sure that the connectors are firmly seated.
 Start the SENSOMASTER software installed on
the PC.
 Switch the torque and angle wrench on.
The connection between the torque and angle
wrench and the PC is established automatically.
For information on operation of the
SENSOMASTER software, refer to the relevant
online help.
Factory settings
The torque and angle wrench is supplied with the
following factory settings:
 Menu language German
 All menus shown
 Password protection switched off
 Automatic switching off after 15 min.
 Alert limit 80 %
 Standard extension length (depending on model)
On resetting to the factory settings, all of the
fastener data contained in the internal torque
and angle wrench memory are deleted. Back
the fastener data up before resetting if
necessary.
Proceed as follows to reset the torque and angle
wrench to the factory settings:
 Connect the torque and angle wrench to the PC.
 Start the SENSOMASTER software installed on
the PC.
 Switch the torque and angle wrench on.
 Select the "Settings" tab.
 Select the "Parameters" tab.
 Click onto the "Factory settings" button.
 Confirm the prompt.
The torque and angle wrench is reset to the factory
settings.
Changing the menu language
The following menu languages can be loaded in the
internal torque and angle wrench memory:
 German (factory setting)
 English
 Italian
 Spanish
 French
 Dutch
 Danish
 Norwegian
 Swedish
 Finnish
 Polish
Further languages on request.
To change the menu language, the
SENSOMASTER software must be installed on a
PC.
Only one menu language is ever available in
the torque and angle wrench at any one time.
The menu language installed using the
SENSOMASTER software replaces the menu
language available in the torque and angle
wrench.
 Connect the torque and angle wrench to the PC.
 Start the SENSOMASTER software installed on
the PC.
 Switch the torque and angle wrench on.
 Select the "Settings" tab.
 Select the "Parameters" tab.
 Select the desired menu language in the "Torque
wrench language setting" area.
 Click onto the "Save data in torque and angle
wrench" symbol.
The torque and angle wrench settings are updated.
The torque and angle wrench switches off and then
switches on again automatically.
41