Stahlwille MANOSKOP 714 Manual De Instrucciones página 106

Using the torque and angle wrench
Working through a sequence plan
WARNING
Danger of severe or fatal injuries due
to an incorrect sequence when
tightening bolts.
 Make sure that the bolts specified by
the sequence plan are tightened in
the relevant, correct sequence.
 If you discover that you have
confused the sequence, the bolting
process must be cancelled
immediately.
 Loosen the bolts and use new bolts if
necessary.
 Repeat bolting.
CAUTION
Danger of injuries due to overloading
the torque and angle wrench.
 In the event of overloading, both
signal lamps initially flash, the torque
and angle wrench triggers during
right-hand tightening and the
acoustic signal is sounded at
intervals.
 In this case, immediately cancel the
bolting process.
 Use a torque and angle wrench
suitable for the load.
 Calibrate the torque and angle
wrench each time after overloading.
46
 Make sure that no forces are acting on the torque
and angle wrench.
 Switch the torque and angle wrench on.
 Call up the desired sequence plan, see page 38.
 Carry out bolting according to the sequence plan.
 Observe and adhere to the instructions provided
from page 43.
When working according to a sequence plan,
the next bolting operation within the sequence
plan is selected at the end of a bolting process.
Following the sequence plan's last bolting
operation, the first bolting operation is
automatically selected.