Publicidad
Idiomas disponibles
Idiomas disponibles
Description
An automatic button lock prevents unintentional
adjustment
Overload protection through acoustic and optical
warning signal plus forced triggering (right)
Automatic indication of the next calibration date
according to time and/or number of cycles
Fully automatic calibration and adjustment with
the following STAHLWILLE calibration and
adjustment facilities:
perfectControl
7794-2 (torque)
®
perfectControl
7794-3 (torque and angle)
®
Various units (N m, ft.lb, in.lb) may be set
Extension length data can be easily input for
special plug-in tools
After relieving the torque and angle wrench, it is
immediately functional again
Tightening to the right and left is possible. For
tightening to the left in click mode, the plug-in tool
may have to be installed rotated by 180°
The torque and angle are shown simultaneously
on the display
Measurement is carried out irrespective of the
force application point in the case of sizes 1, 2
and 4
Safe handling thanks to an ergonomically shaped
handle. The correct gripping position can be seen
and felt
Compensation of inherent bending during angle
measurement.
The torque wrench is available in various sizes (see
page 17).
Identification
The torque wrench is identified with a serial number
which is printed on the model plate.
The serial number may also be shown on the
display using the "Version Info" menu item (see
page 37).
A separate ID number may be set using the
SENSOMASTER software. For further information
on this, refer to the SENSOMASTER software
online help.
Accuracy
The torque and angle wrench corresponds to
DIN EN ISO 6789 and is based on
VDI/VDE 2648 Part 2. Each torque and angle
wrench is supplied with a factory calibration
certificate.
Symbols and markings
The following symbols and markings can be found
on the torque and angle wrench:
CE symbol
The CE symbol confirms full
adherence to the "Basic (safety)
requirements" defined in EU
directives.
Disposal
Do not dispose of the torque and
angle wrench in household
refuse. Dispose of the torque
and angle wrench through a
certified specialist disposal
company.
Handle material
This symbol identifies the
material used in the handle
(polyamide) for recycling.
11
Publicidad
