Stahlwille MANOSKOP 714 Manual De Instrucciones página 97

Basic menu operation
Version Info menu item
Torque and Angle Wrench Status
Basic menu operation
Moving in the menus
 Use the two arrow buttons to select a menu item.
The menu item is marked.
 To carry out further settings for a menu item or to
confirm a setting, press OK.
 To move back step by step in the menu or to
cancel inputs, press HOME.
Inputting values
The necessary data for a bolting operation are
queried in the direct inputs. The arrow buttons can
be used to increase or reduce the values.
 To increase or reduce the value slowly, briefly
press the corresponding arrow button once.
 To increase or reduce the value quickly, keep the
corresponding arrow button pressed.
 Once the desired value has been set, press OK.
The following information is provided here:
 Type/torque range
 S/N
 ID of the torque and angle wrench
 Firmware version
 Bootloader version
 Hardware version
Calling up direct input
Concrete values for a bolting operation are defined
in direct input.
Proceed as follows to select one of the measuring
modes:
 Make sure that no forces are acting on the torque
and angle wrench.
 Switch the torque and angle wrench on.
 Press the MENU button for approx. one second.
DIRECT INPUT is shown on the display.
The sequence plans defined using the
SENSOMASTER software and transferred to
the torque and angle wrench are also available
in this menu. (See page 38).
 Confirm with OK.
37