TRAPP TR-600 Manual De Instrucciones página 46

Attention!
Read all instructions herein before operating the
equipment. Always observe and follow safety
instructions to prevent accidents and/or injuries.
Residues Shredders models TR-600/600E/600G
and 600T are designed to cut trimmed wood
residues, branches, chips, bushes, wood of
diameter up to 10 cm, package residues and other
wooden structures free from nails, wire or other
metals. Any other use poses a risk to the integrity
and to the safety of the operator, furthermore, it
may damage the machine.
Important:
Recently trimmed material must
dry a little before being shredded. It increases
the performance of the shredder, providing better
residue composting.
The equipment must be installed in an open,

well-ventilated environment on solid, flat
ground.
Keep children and spectators away. People,

especially children, must remain at a safe
distance from the working area - 30m - when
the equipment is being used. The operator/
user is responsible for accidents that may
occur.
Do not allow people to touch the machine

while being used or transported.
Do not lubricate, clean or adjust movable

components while they are moving or when
the machine is being lifted.
When maintaining or adjusting the equipment,

do not use your hands in operations that can
be done with specific tools.
Do neither use bad tools nor use them

inadequately (e.g. pliers instead of wrenches,
etc.).
46
Shredder Usage
Before servicing hydraulic lines under

pressure, switch their components off, making
sure the line is not under pressure and the
liquid in not hot.
After maintenance or repair, make sure tools,

cloths or other materials/objects were not left
inside gaps or guides with movable parts.
When using the equipment, only one person

must give instructions and signalize the
direction of loads.
Maximum diameter of branches to be fed

must be 10 cm.
Remove weird objects such as metal, glass or

stones before turning machine on.
Just remove protection lid when machine

comes to a stop.
Turn shredder on and wait for maximum

revolution to be reached to insert materials.
TRAPP is not responsible for damages caused

due to failure to observe the instructions in
this manual.
Tractor discharge power indications -
TR-600T
Only operate shredder if properly connected

to the three connecting points of tractor.
The shredder can be transported by a tractor.

However, if the equipment has to be coupled
in the place itself, it must be flat, compacted
soil, of enough dimensions to operate it.
Never lift the machine when tractor discharge

power is on.
www.trapp.com.br