TRAPP TR-600 Manual De Instrucciones página 57

www.trapp.com.br
A
Sharpen and replace blades
A good performance of the shredder usually
depends on how sharp blades are. Blades are
reversible and have two cutting edges to be used
before sharpening or replacement. To disassemble
blades:
Repeat procedures in item "Check Blades".

Turn disk until blade screws are accessible.

Loosen securing screws (A) and remove blade (B).

Turn blades 180
O

edge.
Replace screws and washers. Tighten with

a torque wrench according to table "Torque
Specifications".
Repeat the operation for remaining blades.

Remove the blades
A
B
to use the good cutting
B
Rotate the blades
A
If both edges of the blade are worn, sharpen them.
If they are entirely worn or damaged, replace
them. Get in touch with the TRAPP nearest
Technical Assistance.
Blades must be sharpened with proper machines
to assure adequate sharpening. Respect the angle
indicated in the figure below.
Fig. 5
Attention!
A
Do not replace just part of the set of blades.
Always replace the whole set for rotor
balance and to prevent vibration.
Every time blades are removed (disassembled/
reassembled), check adjustment and distance
between blade and counter-blade before turning
on the machine. To adjust the position of the
counter-blade:
Remove locking screws (4).

Turn the disc (1), bringing blades (2) near the

counter-blade (3).
B
B
57
1
2
5
4
3