TRAPP TR-600 Manual De Instrucciones página 58

Adjust the position of counter-blade (3)

with adjustment nut (5), allowing a distance
between blade and counterblade between
2.8 mm (0.110.") and 3.5 mm (0.138.").
Make sure the distance is the same for all

blades.
Lock adjustment nuts (5) and tighten securing

screw (4) with a torque wrench, as shown in
table "Torque Specifications".
Counter-blade
adjustment
1
Ajuste da
contra faca
2
5
4
3
Check belt stretching
Belts are provided with an automatic stretcher,
spring, which needs to be checked. To either
increase or decrease belt stretching, do as follows:
Stop the machine.

Remove ignition key and disassemble cardan.

Remove screws from both transmission

protections - upper and lower.
Remove both protections.

Use nuts (A) and threaded rod (B) to stretch

or loosen spring (C), pressure of 9 kg (20 lb).
58



2.8 - 3.5
Battery
The TR-600G is provided with a system that
sufficiently charges battery for normal use. You
can extend battery life by periodically charging it
with an automotive charger.



If necessary, replace spring, but first
disassemble the threaded rod.
Place the new spring and apply the correct
pressure.
Replace the two belt protections, and tighten
screws.
FORCE
C
B
A
Image for illustrative purposes only
Always keep battery and terminals clean.
Keep battery screws tight.
Recharge battery with as indicated by the
manufacturer.
Note:
The battery of your equipment does not

require maintenance. Do not attempt
to remove covers. You do not need
to check or complete the level of the
electrolyte.
www.trapp.com.br
Belt tension
adjustment
9 kg