Toro 51946 Manual Del Operador página 12

Operation
WARNING:
Do not allow familiarity with this product to
make you careless. Remember that a careless
fraction of a second is sufficient to inflict
serious injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1, along with
hearing protection. Head protection may also
be required depending on the type of attach-
ment used and as prescribed in the attachment's
Operator's Manual. Failure to do so could result
in objects being thrown into your eyes and other
possible serious injuries.
WARNING:
Never use flailing devices, wire, or rope on this
product. Do not use any attachments or acces-
sories not recommended by the manufacturer of
this tool. The use of attachments or accessories
not recommended can result in serious personal
injury.
WARNING:
Operation of this equipment can create sparks
that can start fires around dry vegetation. A spark
arrestor may be required. The operator should
contact local fire agencies for laws or regulations
relating to fire prevention requirements.
Applications
Use this product for the following applications when used
with the appropriate attachment:
■ Cutting grass, weeds, and light undergrowth
■ Edging along sidewalks and driveways
Fueling and Refueling the Power Head
WARNING:
Gasoline and its vapors are highly flammable
and explosive. To prevent serious personal
injury and property damage, handle it with care.
Keep away from ignition sources and open
flames, handle outdoors only, do not smoke and
wipe up spills immediately.
12
Fuel Mixture
This product is powered by a 2-cycle engine and requires
pre-mixing gasoline and 2-cycle lubricant. Pre-mix unleaded
gasoline and 2-cycle engine lubricant in a clean container
approved for gasoline. DO NOT mix quantities larger than
usable in a 30-day period.
Recommended fuel: This engine is certified to operate on
unleaded gasoline intended for automotive use.
Note: We recommend you use high-quality synthetic
2-cycle lubricant in this product. Mix at 2.6 oz. per gallon
(US).
Do not use automotive lubricant or 2-cycle outboard
lubricant.
HIGH QUALITY 2-CYCLE ENGINE LUBRICANT
GASOLINE
1.0 gal. (US) (3.8 liter)
2.5 gal. (US) (9.5 liter)
Filling Tank
■ Clean surface around fuel cap to prevent contamination.
■ Loosen fuel cap slowly by turning counterclockwise. Rest
the cap on a clean surface.
■ Carefully pour fuel into the tank. Avoid spillage.
■ Prior to replacing the fuel cap, clean and inspect the gasket.
■ Immediately replace fuel cap and hand tighten by turning
clockwise. Wipe up any fuel spillage.
■ Move at least 30 ft. (9 m) away from refueling area before
starting the product.
Note: It is normal for smoke to be emitted from a new
engine after first use.
WARNING:
Always shut off engine before fueling. Never
add fuel to a machine with a running or hot
engine. Move at least 30 ft
site before starting engine. Do not smoke and
stay away from open flames and sparks. Fail-
ure to safely handle fuel could result in serious
personal injury.
OXYGENATED FUELS
NOTICE: DO NOT USE E15 OR E85 FUEL IN THIS
UNIT. IT IS A VIOLATION OF FEDERAL LAW
AND WILL DAMAGE THE UNIT AND VOID YOUR
WARRANTY.
NOTE: Fuel system damage or performance problems
resulting from the use of an oxygenated fuel containing
more than the percentage of oxygenates stated below are
not covered under warranty.
LUBRICANT
2.6 oz. (76 ml)
6.4 oz. (189 ml)
. from refueling
(9 m)
Operation