Publicidad
Idiomas disponibles
Idiomas disponibles
Operation Instructions
CHECKING FOR LEAKS
After all connections are made, check all connections and fittings on the natural gas quick connector, gas
hose and manifold for leaks with a water and soap solution.
Always perform leak test prior to lighting the grill.
Do not smoke while testing for a leak.
Always perform leak tests outdoors in a well-ventilated area.
Do not use any source of flame while testing for leaks.
Do not use the grill until any and all leaks are corrected.
If you are unable to correct a leak, close the natural gas shut-off and call a gas appliance service
agency.
PERFORM LEAK TEST
Prepare leak test solution by combining a 50/50 ratio of liquid dish soap and water.
Put leak test solution in a spray bottle.
Ensure all control knobs are in the "O OFF" position.
Connect the gas hose to the gas supply.
Open the gas shut-off valve.
Spray leak test solution on all gas carrying connections and fittings. Presence of bubbles at areas of
applied test solution indicates a gas leak. If leaks are detected or you smell or hear gas, shut off the
gas supply valve immediately and repair or replace the defective part. Do not use the grill until all
leaks are corrected.
Only use the hose assembly provided! If a replacement is necessary, please call
our customer service center. Do not use replacement parts that are not intended for this grill.
ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE FOLLOWED TO PREVENT
FIRE, DAMAGE AND/OR INJURY.
CAUTION
WARNING
18
Publicidad
