KIT 8 (CODE 297360)
NOTE: THE FIRST PART OF THE FLEXIBLE PIPE MUST BE COMPLETELY "RELAXED" IN SUCH A
WAY TO ELIMINATE CORRUGATION. IN THIS WAY, THE INTERNAL DIAMETER WILL BE SLIGHTLY
ENLARGED TO FAVOUR ENTRANCE.
- Defi ne the position of the stove with respect to the walling (fi g. a).
- Enable the hot air channelling control lever (see page 39).
- Place the stove in its fi nal position and fasten it to the wall using the supplied brackets (A and B) or, if necessary, an
alternative system that will ensure the stove's stability (see fi g. 2).
- Extend the aluminium pipe (2 - fi g.1) for hot air channelling, without connecting the stove outlet.
- Fit the aluminium pipe to the hot air outlet (A).
- Install the terminal outlet (3) and its aluminium pipe (2).
Properly insulate the pipe in which the hot air passes in order to avoid heat dispersion.
2
fi g. 1
EXAMPLES OFWARM AIR CHANNELLING AND SMOKE EXHAUSTS
from the top
INSTALLATION
1
A
from the back
KIT 8
Pipe blocking clamp
Ø 10 pipe
Smoke outle tend-piece
A
B
fi g. 2
from the side
- 29
-
n°
code
2
46160
1
162520
1
293430