Publicidad
Idiomas disponibles
Idiomas disponibles
Before you proceed to operate the camera, acquaint yourself thoroughly
with the present manual and observe the safety regulations and specifica-
tions defined by the producer.
Any application that differs from those specified in this manual may
result in damage to the device and constitute a source of danger for
the user.
The camera must not be used in rooms where special conditions are
present e.g. fire and explosion risk.
It is forbidden to use damaged or malfunctioning camera.
Do not use any other adapter than the one supplied with the camera.
Repairs may be performed only by an authorised service point.
KT-120M thermal camera is designed to measure and record the images
in the infrared. It is designed to provide the user with maximum perfor-
mance and safety during the work. However, the following guidelines and
recommendations must be observed at all times (in addition to all binding
precautions applicable at individual work stands and work areas):
Keep the camera steady when performing the measurements.
Do not use the camera in temperatures exceeding its working and
storage temperature ranges.
Do not direct the camera toward very high intensity radiation
sources such as the sun, lasers or welding arcs etc.
Do not expose the camera to dust and moisture. When operating the
device near water, ensure that it is adequately guarded against
splashes.
When the camera is not in use or is to be transported, ensure that the
unit and its accessories are stored in the protective carry case.
Do not re-switch on the camera until 15 seconds later after switching
it off.
Do not throw, knock or shake intensely the camera and its compo-
nents in order to avoid the damage.
Do not attempt to open the camera body, as this action will void the
warranty.
Use only the SD memory card supplied with the camera.
22
1
Safety
KT-120M – USER MANUAL
Publicidad
