Makita DRT50 Manual De Instrucciones página 16

1
3
► 1. Trimmer bit 2. Templet guide 3. Distance (X)
4. Outside diameter of templet guide
Using the trimmer guide
Optional accessory
The trimmer guide allows for trimming curved side like
veneers for furniture by moving the guide roller along
the side of the workpiece.
1.
Loosen the clamp screw, then install the trimmer
guide on the trimmer base, and then tighten the clamp
screw.
1
► 1. Clamp screw
2
4
2. Loosen the clamp screw and adjust the distance
between the trimmer bit and the trimmer guide by turn-
ing the adjusting screw (1 mm (3/64") per turn). At the
desired distance, tighten the clamp screw to secure the
trimmer guide.
1
► 1. Adjusting screw 2. Clamp screw
3.
Move the tool with the guide roller riding the side
of the workpiece.
1
► 1. Workpiece 2. Bit 3. Guide roller
Using the tool with the tilt base
The tilt base is convenient for chamfering. Loosen the
wing screws, then tilt the tool at the desired angle, and
then tighten the wing screws.
Firmly clamp a straight board to the workpiece and use
it as a guide against the tilt base. Feed the tool in the
direction of the arrow.
► 1. Wing screw
16 ENGLISH
2
1
2
3