Publicidad
Idiomas disponibles
Idiomas disponibles
During Child Lock, if user touch any
sensor (Main sensor included) , "L"
will flash on display.
Warning : Child lock status is not
being stored. If the energy of the hob
is butted, child lock status could not
be preserved.
Deactivating Child Lock :
To be able to deactivate Child Lock,
the Child Lock should be activated
before and all power display show "L"
1.
(5) Increase power touch key
and
(4) decrease power touch
key and minus sensors is hold for
3 seconds at same time. At the end
of the this period, a short buzzer
sound is heard,
2. After buzzer signal , is touched to
the
(7) locking touch key (there
is no need to keep press for a long
time) and a long buzzer sound is
heard and the Child Lock will be
de activated and "Indication will
be light off.
Flash Cooking
(Automatic cook start)
This function facilitates cooking as
you do not need to be present while
it is being done. The touch control
pre-programmes the chosen hot
plate at the maximum power and
subsequently lowers it to the desired
power level (which you have selected)
after an approximate amount of time
(see table 1).
Table 1
Selected
Automatic Cook Start
Function
power
0
1
60
2
180
3
288
4
390
5
510
6
150
7
210
8
270
9
SWITCHING THE AUTOMATIC
COOK START FUNCTION ON
1 The hot plate must be selected.
2 Select power 9 and then press
power touch key
the touch key you must lower the
continuous cooking power to the
desired level, (for example 6).
When the automatic cook function
starts "A" indication flashes with
desired power level on the display.
SWITCHING THE AUTOMATIC
COOK START FUNCTION OFF
After at least 10 seconds have elapsed
since the beginning of the automatic
cook start function:
1 The hot plate must be selected.
2 Press touch key
indicator reaches level 9 and the
automatic cook start function will
be deactivated.
Timer Function
This function makes it easier to cook,
as you do not need to be present
throughout the process: the timed hot
plate(s) will switch off automatically
after the set time has lapsed. There
is a separate timer for each hot plate,
which allows all of the hot plates to be
timed simultaneously.
With these models you can use the
clock as a timer for the hotplates for
times ranging from 1 to 99 minutes. All
the cooking areas can be programmed
individually and in a simultaneous
manner.
TIMING ONE HOTPLATE
0
1 The cooking zone to be timed must
be selected.
2 Select a power level for the hotplate
from 1 to 9 using the touch keys
or
(5/4).
3 Press clock touch key
indicator (12) will display 00. Timed
hot plate display (11) will flash.
-
4 Immediately afterwards, enter a
cooking time between 1 and 99
minutes, by using the touch keys or
(5/4).
When the power indicator (3) stops
flashing, it will start to count down the
(5).After using
time automatically. The respective
timed hotplate disolay (11) will
continue flashing.
When the clock reaches 01, it will
switch from counting down minutes
to seconds.
Once the selected cooking time has
elapsed, the heating zone being timed
is turned off and the clock emits a
series of beeps for several seconds.
The timer indicator will display a
flashing 00 beside the hotplate that
has been disconnected.
If you wish to time another hotplate at
(5) till the
the same time, repeat steps 3 and 4.
If the heating zone turned off is hot, its
indicator displays an H or otherwise an
0. To turn off the audible signal touch
any sensor.
CHANGING THE PROGRAMMED
TIME
To change the progrmmed time, you
must press the touch key of the timed
hotplate (2) to select it and then the
clock
change the time.
DISCONNECTION OF THE TIMER
If you want to stop the timer before the
programmed time is up
1 First select the hotplate and then
press clock touch key
2 Use the touch key
recude the time to 00. The clock is
cancelled.
Alternative metod :
After zone selection if timer touch key
is pressed for two seconds, the related
timer will be cancelled.
Safety switch off function
(10). Timer
If due to an error one or several hot
plates do not switch off, the appliance
will be automatically disconnected
after a set amount of time (see table 2).
EN
(10). You may then read and
(10).
(4) to
21
Publicidad
