Stihl RE 521 Manual De Instrucciones página 41

Unsuitable detergents can cause
–
damage to health, as well as to the
machine and the object to be
cleaned. Contact a servicing dealer
if in doubt.
STIHL recommends the use of
–
genuine STIHL detergents. Follow
the instructions for use.
Chemical detergents may contain
–
physiologically harmful (toxic,
caustic, irritant), flammable or
explosive substances. In the event
of skin or eye contact with
detergent, flush the affected body
parts with plenty of clean water
immediately. If detergent is
swallowed, seek medical attention
immediately. Note the
manufacturer's safety data sheets!
Detergents should always be used in the
proportions specified by the
manufacturer.
Before starting work
Do not use the machine with dirty water.
If there is a risk that dirty water will occur
(e. g., flowing sand), an appropriate
water filter must be used.
Switch off the machine before filling with
fuel.
The fuel tank may only be filled when the
machine is switched off and the heat
exchanger is cold. Do not smoke and
keep the machine away from naked
lights.
Inspecting the high-pressure cleaner
Warning!
RE 521, RE 551 PLUS, RE 581, RE 581 PLUS
The high-pressure cleaner should
–
only be used if it is in full working
order – risk of accident!
It must be possible to move the
–
switch to the 0 position easily
The switch must be in the 0 position
–
Inspect the high-pressure hose,
–
spray attachment and safety
mechanisms for damage
High-pressure hose and spray
–
attachment in good condition
(clean, moving easily) and correctly
assembled
For good control of the machine, the
–
handles should be clean and dry
with no oil or dirt on them
Check the oil level
–
Never attempt to modify the controls
–
or safety devices
Electrical connection
Warning!
Minimize the risk of electrical shock:
Voltage and frequency of the
–
machine (see rating plate) must
match the voltage and frequency of
the mains supply
Examine the power cord, power
–
plug and extension cord for
damage. Damaged cords,
couplings and plugs or power cords
that do not comply with the
regulations must not be used
Only connect the machine to a
–
correctly installed power socket
The insulation on the power cord
–
and any extension cord, the plug
and the coupling must be fully intact
Warning!
Route the power cord and extension
cord properly:
Observe the minimum cross-section
–
of the individual cords – see
"Connecting the machine to the
power supply"
Route and mark the power cord so
–
that it cannot become damaged and
no one is endangered – danger of
stumbling!
The connector and coupling of the
–
extension cord must be waterproof
or routed in such a way that they
cannot come into contact with water
– the connector and coupling of the
extension cord must not lie in water
don't let the cord rub against edges
–
or pointed or sharp objects
don't squeeze the cord under doors
–
or windows
if cords become snarled – unplug
–
the power plug and unsnarl the cord
always unroll the power cord from
–
the cable drum completely to avoid
risk of fire due to overheating
During work
Warning!
English
39