Descargar Imprimir esta página

Sicce ULTRA 9000 Manual De Instrucciones página 10

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
Dear Customer
EN
THANK YOU for choosing ULTRA 9000, a submersible pump designed and built to pump turbid water without
¿ bres. ULTRA 9000 can be used mainly for domestic use with continuous or automatic operation via the
IT
integrated electronic level switch, for draining basements and garages subject to À ooding, for pumping drainage
wells, for pumping rainwater collection wells or in¿ ltrations from gutters, to empty swimming pools or pool
DE
covers with the aid of the horizontal suction ¿ tting supplied. If used continuously, ULTRA 9000 is also ideal for
ponds, fountains, waterfalls, hydroponic applications and aquariums.
FR
ES
NL
PT
CZ
1.
Check that the tension on the pump's label matchs the network tension. The pump has to be supplied by a
differential switch (protector), through which the nominal current is lower or equal to 30mA.
SK
2.
These pumps can be used only submersed in water.
3.
Before connecting the pump to the electric network, check that the cable and the pump are not damaged.
RO
4.
The pump has a type Z cable link. The cable and the plug cannot be substituted or repaired; in case of
damage of them substitute the entire pump.
PL
5.
in case the plug or the electric outlet are damaged, disconnect the general switch before disconnecting the
SE
electric supply cable.
6.
The pump must not work without water to avoid damages to the motor.
DK
7.
The pump can be used in liquids or in environment with a temperature not higher than 35° C / 95° F.
8.
Do not use the pump for uses different to those for which it has been designed as, i.e. in bathroom or similar
NO
applications.
9.
Avoid to use the pump with corrosive and abrasive liquids.
10. The pump has not been designed for people with handicap and children if they are not supervised by a
person responsible for their safety.
11.
To avoid that accidental drips wet the plug or the socket, make a loop with the cord under the socket level
(
12. Avoid to take the pump by the cord during the installation or maintenance.
13. The pump can be used only in the above mentioned applications.
Use in cellars, basements, swimming pools, etc. it is allowed only if the electrical system is characterized by
safety measures according to the international regulations in force.
The pump is equipped with a carrying handle, which can also be used to lower it into wells or deep excavations
by means of a rope to be ¿ xed on the hole present.
The pump must not be transported, lifted or operated suspended using the power cord. Any damage to the
power cord requires replacement of the pump and not repair of the cord.
It is therefore necessary to make use of specialized and quali¿ ed personnel, in possession of the requisites
required by current regulations. Quali¿ ed personnel should also be used for all electrical repairs which, if
performed incorrectly, could cause damage and injury.
The pump must never be run dry: however, there is an electronic protection that switches off the pump in the
event of dry running. The manufacturer is not liable for malfunctioning of the pump if it is tampered with or
modi¿ ed. In the event that the bottom of the sump, where the pump is to operate, is heavily soiled, it is advisable
10
to provide a support on which to rest the pump in order to avoid blockages in the suction grille.
is made in conformity with the national and international security law.
disconnect all the submersed electrical products before doing any maintenance in the water;
).

Publicidad

loading

Productos relacionados para Sicce ULTRA 9000