Sicce ULTRA 9000 Manual De Instrucciones página 4

Always disconnect the pump when not in use, before adding or removing parts and before
cleaning.
- Do not allow pump to run dry. Pump must be immersed in water completely.
- This pump is to be used in a circuit protected by a ground fault circuit interrupter.
Risk of electric shock - This pump is supplied with a grounding conductor and grounding-type
attachment plug. To reduce the risk of electric
shock, be certain that it is connected only to a
properly grounded, grounding-type receptacle.
- To reduce the risk of electric shock, install
only on a circuit protected by a Ground -
Fault Circuit - Interrupter (GFCI).
- To reduce the risk of electric shock, use only
on portable self-contained fountain no large
than 5 feet in any dimension.
- This pump has not been investigated for use
in swimming pool or marine areas.
- To avoid possible electric shock, special care
should be taken since water is employed
in the use of aquarium or pond equipment.
For each of the following situations, do not
attempt repairs by yourself. Return the appliance to an authorized service facility
for service or discard the appliance.
1) Do not operate any appliance if it has a damaged cord or plug, or if it doesn't work
properly or has been dropped or damaged in any manner.
2) To avoid the possibility of the appliance plug or receptacle getting wet, position
aquarium stand and tank or the fountain to one side of a wall-mounted receptacle
to prevent water from dripping onto the receptacle or plug.
A "drip-loop" (Pic. A) should be arranged by the user for each cord connecting an
aquarium appliance to a receptacle.
Pic. A
AQUARIUM TANK
POWER
SUPPLY CORD
APPLIANCE
DRIP LOOP