Sicce ULTRA 9000 Manual De Instrucciones página 5

The "drip-loop" is the part of the cord below the level of the receptacle or the connector if an extension
cord is used, which prevents water travelling along the cord and coming in contact with the receptacle.
If the plug or socket does get wet, DON'T unplug the cord. Disconnect the fuse or circuit breaker that
supplies power to appliance. Then unplug and examine for presence of water in the receptacle.
3) Close supervision is necessary when any appliance is used by near children.
4) To avoid injury, do not contact moving parts or hot parts such as heaters, reÀ ectors, lamp bulbs and
similar.
5) Always unplug an appliance from an outlet when not in use, before putting on or taking off parts and
before cleaning.
Never yank cord to pull plug from outlet. Grasp the plug and pull to disconnect.
6) Do not use an appliance for other than intended use. The use of attachments, not recommended or sold
by the manufacturer of the appliance, may cause an unsafe condition.
7) Do not install or store the appliances where it will be exposed to the weather or to temperatures below
freezing.
8) Make sure an appliance mounted on a tank is securely installed before operating it.
9) Read and observe all the important notices of the appliance.
10) If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less
amperes or watts than the appliance rating may overheat. Care should be taken to arrange the cord so
that it will not be tripped over or pulled.
11) This appliance has a polarized plug (one blade is wider than other). As a safety feature, this plug will
¿ t in a polarized outlet only one way. If the plug does not ¿ t fully in the outlet, reverse the plug. If it still
does not ¿ t, contact a quali¿ ed electrician. Never use with an extension cord unless plug can be fully
inserted. Do no attempt to defeat this safety feature.
This appliance should be grounded to minimize the possibility of electric shock. This appliance is equipped
with an electric cord having an equipment gounding conductor and a grounding type plug. The plug must
be plugged into an outlet that is installed and grounded in accordance with all appropriate codes and
ordinances.
This appliance is for use on a nominal 120-volt circuit, and has a grounding plug that looks like the plug
illustrated in (I). A temporary adapter which looks like the adapter illustrated in (II) and (III) may be used
to connect this plug to a two-pole receptacle as shown in (II) if a grounded outlet is not available. The
temporary adapter should be used only until a grounded outlet is not available. The temporary adapter
should be used only until a grounded outlet can be installed by a quali¿ ed electrician. The green-colored
rigid ear (lug, and the like) extending from the adapter must be fastened to a permanent ground such as
a grounded outlet box.