Vacmaster VK1330PWR Manual página 15

10) Turn on the motor by assigning the switch to the "I" ON position. Press the detergent selection
mode button, indicated by the following symbol
vacuum head and operate the vacuum for detergent application only. Select both the detergent
mode and vacuum mode for simultaneous detergent application and wet vacuuming (Fig. 28).
WARNING!
CONTAINER IS FULL OR BLOCKED. STOP THE VACUUM IMMEDIATELY AND EMPTY
THE CONTAINER.
11) Once you have completed cleaning, switch off the vacuum by pressing detergent mode button
on either the remote control handle or the vacuum head. Switch to the "O" OFF position,
unplug the power cord from the power outlet and drain the liquid (Fig. 29).
NOTE:
• Vacuum the carpet/upholstery thoroughly before washing it. For carpet cleaning it is
recommended to remove all furniture from the room to be cleaned or move it away from the
cleaning area. Clean the whole carpet systematically in squares of approximately 1.5m each.
This avoids walking over the cleaned carpet until it is completely dry.
• Start furthest away from the doorway to the room, extend the hose and work backwards.
• Pull the carpet lance back towards you, in lengths of approximate 1.5m. Refill the detergent
tank if the fluid spray stops.
• Select the vacuum mode, indicated by the following symbol
and repeat the wet vacuuming steps. Apply more detergent particularly in any dirty area. The
dirty solution is visible as it is sucked up through the carpet lance. Stop vacuuming when there
is no more dirty fluid.
• Do not walk over any newly cleaned area until it is completely dry.
• The handheld lance is ideal for cleaning sofas, chairs, stairs and car interiors.
• The carpet lance is ideal for cleaning carpets.
WARNING!
COMPLETELY DRY!
THE MOTOR NOISE CHANGES TO A HIGHER PITCH WHEN THE
DO NOT REPLACE FURNITURE UNTIL THE CARPET IS
15
, on either the remote control handle or the
, to suck up the dirty solution
GB