Tramontina TCP-320L Manual De Uso Seguro Y Adecuado página 18

STEP 2
Hold the existing pin on the leg (item 1) and insert it into the securing hole of the
outer holder (item 2) according to picture 04. Make sure that the hole of the outer
holder is facing the inside of the grill structure. Repeat the same procedure for the
other two legs. To assemble the chrome steel triangle (item 8), align the hole of the
outer holder as well as the leg holes properly.
Picture 04
STEP 3
Position the chrome steel triangle (item 8) and secure it with M5 screws (item 9) as
shown in figure 05.
Picture 05
STEP 4
Place the charcoal tray (item 5) on the supports of the three inner holders according
to picture 06. Then place the cooking grate (item 4) on the upper supports of these
same holders as shown in picture 07.
4
Picture 06
2
1
9
8
5
Picture 07
STEP 5
Attach the air outlet (item 15) to the lid together with an M6 screw (item 10) according
to picture 08. Then place the metallic washer (item 18), the lock washer (item 19),
and an M6 nut (item 11) as shown in picture 09. (The lock washer must be between
the metallic washer and the nut).
Picture 08
STEP 6
Insert two M6 screws (item 10) into the handle holes (item 13) and attach the handle
with the screws to the lid (item 12) according to picture 10. Hold the handle against
the lid and align the inner holder (item 16) with the same screws of the handle. Then
secure the M6 nuts (item 11) and tighten them as shown in picture 11.
13
10
Picture 10
STEP 7
Attach the thermometer (item 14) using its metallic washer (item 20) and a wing nut
(item 17) as shown in pictures 12 and 13.
Picture 12
18
15
10
12
16
14
17
20
11
19
18
Picture 09
11
Picture 11
Picture 13