Tramontina TCP-320L Manual De Uso Seguro Y Adecuado página 20

3.3.2. Assembly instructions
STEP 1
Firstly, align the M6 screw (item 11) with a metallic washer (item 13) and then with a
ceramic washer (item 12). Place the screws with the washers on the inside of the bowl
(item 9) and position the handle (item 14) on the outside of the bowl. Next, secure
them, as shown in pictures 01 and 02. Repeat the same procedure for the other two
sets of holders.
11
13
12
Picture 01
4
STEP 2
Attach the handle (item 10) to the bowl (item 9) using the M6 screw (item 11),
metallic washers (item 13), ceramic washers (item 12), and the M6 nut (item 25) as
shown in picture 03.
(The ceramic washer must be between the bowl and the metallic washer).
12
11
10
Picture 03
STEP 3
First place the ceramic washer (item 12) on the inside of the bowl (item 9), then place
the metallic washer (item 13) and secure the headless screw (item 14). Align the
ceramic washer (item 12) and the metallic washer (item 13) on the outside of the bowl
and secure them using the M6 wing nut (item 23), as shown in Picture 04.
Picture 04
Picture 02
25
13
9
14
13
12
9
12
13
23
STEP 4
In this step, start the assembly with the front leg (item 1), hold the existing pin on the
leg and insert it into the securing hole of the outer holder (item 4) that is closer to the
handle, according to picture 05.
Make sure that the holder hole that locks the leg of the outer is facing the center of the
bowl. Then, attach the lower metallic grate (item 5) to the front leg (item 1), as shown
in picture 06. Place the lower metal grate into the hole in the legs before assembling
them on the stand as shown on figure 7 and repeat the same assembly procedute
described above, observing that the legs are positioned correctly (the lower part of
the legs should be parallel to the wheels), as shown on figure 8. If that is not the case,
reverse the legs and carry on with the assembly procedure.
4
9
Picture 05
Picture 07
STEP 5
Position the wheel (part 6) on the axis of the metallic grate (part 5) using the wheel
cotter pin (part 27). Then attach the wheel covers (part 7), as shown in figures 9, 10,
and 11.
5
Picture 09
20
1
1
Picture 06
5
6
27
7
Picture 10
Picture 08