Publicidad
Idiomas disponibles
Idiomas disponibles
Please note: The side door sill covers for the left- and right-hand side of the
EN
vehicle are different; make sure that you use the correct door sill cover on each
side of the vehicle. Do not remove the protective sheet strips until just before
you actually adhere the door sill cover.
- Fig. 7, 8 -
- Carefully line up the door sill cover with the marks and gently press down on it.
Please note: When positioning the side door sill covers on the vehicle sill during
the adhesion procedure, always proceed with the utmost care. Sufficient
adhesion is not guaranteed if the side door sill covers are removed and then
readhered. It is therefore important to ensure that they are positioned correctly
before you actually come to adhere them.
- Check that the door sill cover is positioned correctly. If it is, carefully press down on the side door sill cover
by hand (with a contact pressure of at least 80 N).
- Fig. 9 -
- Use the templates to correctly position the door sill cover on the vehicle sills. Always position the correct
template (left/right) on the vehicle sill, as shown in the figure.
- The shape of templates for rear door sill covers matches perfectly the shape of the door sill and B-pillar.
- Use a suitable felt-tip pen (0,5 mm) to make marks where the covers are to be positioned on the vehicle
sills. Make sure that you draw the line along the outer edge of each of the openings – the openings are
indicated by black arrows on a green background.
- Fig. 10 -
- Remove the template.
- Place the foil onto the vehicle sill, lining it up with the marks you have made. Check that the cover is posi-
tioned correctly in relation to the other components on the vehicle (door seal, recess in the sill, etc.).
- Hold the cover in place and draw marks along its back end and sides to show where it should be positioned.
- Fig. 11 -
- Remove the protective cover from the adhesive (bottom) side of the door sill cover.
Please note: Make sure you distinguish between right and left door sill covers.
Remove the covering foil immediately before attaching the door sill cover.
- Fig. 12, 13 -
- Check whether the foil has been correctly adhered. If it has, carefully press down on the door sill cover by
hand (with a contact pressure of at least 80 N).
- Fig. 14, 15 -
- Press down on the side door sill cover again approximately 15 minutes after adhering it. Use a clean microfi-
bre cloth to do this.
- Use a suitable cleaning agent to clean off the guide marks.
- The procedure for adhering the door sill cover to the vehicle sill on the other side of the vehicle is the
same.
- Fig. 16 -
- Once the door sill coveres have been adhered, the vehicle must be stored in a protected environment for 6
hours (at a temperature between 18 and 30 °C).
12
Publicidad
