Publicidad
448SW-BCSC-5C directions:
STEP 1
Adjust the back stop by loosening
the (2) screws on the inside of the
frame using a #2 screwdriver (See
Figure 1).
#2
STEP 2
Remove the #6 x 1/2 flat head
screws from the lever lock
mounting bracket. (See Figure 2).
#2
#2
#2
STEP 3
Line up the release lever with the
(2) holes from the back mounting
bracket. Flip the two pieces over
and attach the release lever to the
mounting bracket using (2) M4 X 6
flat head screws (See Figure 3).
#2
#2
#2
STEP 4
Using the (7) #6 x 1/2 flat head
screws, screw the bracket with the
lock lever attached back into the
frame. (See Figure 3).
Place the lock shaft on the lock
trigger as shown (See Figure 4).
#2
#2
#2
2
FIG. 1
FIG.2
FIG.3
#2
Screw locations
FIG. 4
Customer Service: 800-626-1126 | rev-a-shelf.com
Loosen
Lever lock mounting bracket
Screw locations
Lock Shaft
Lock lever mounting bracket
Bottom View
Publicidad
