Publicidad
448SW-BCSC-5C/8 directions for stop:
STEP 1
Using the (2) 10-32 X 1/2 Phillips
head screws and (2) 10-32 Nylock
nuts, attach the BLUM "stop" to
the 448 slide lock sub assembly
(See Figure 1).
#2
#2
#2
STEP 2
Using the dimensions from
Figure 2 mark your hole locations
accordingly. Using a 5/64 bit
pre-drill and then screw in the
lever lock mounting bracket and
attached stop with (2) #6 x 1/2 pan
head screws (See Figure 2).
Notes: Repeat steps on other
side of cabinet if installing an
8C. If installing a 5C make sure
and install the mounting bracket
and stop on the same side as the
Blum release lever.
#2
#2
#2
STEP 3
Use your slide set template to
complete the installation.
4
FIG. 1
FIG. 2
Customer Service: 800-626-1126 | rev-a-shelf.com
Stop
Back View
Nylock Nuts
1-5/8"
(41 mm)
5/8"
from inside
(16 mm)
of face frame
20-13/32"
(518 mm)
Publicidad
