Front of device and operating panel
Clean the front of the device and the operating panel with a soft, slightly damp cloth.
Please bear in mind that the operating panel does not get wet. Use a soft, damp cloth
for cleaning.
► Leave the oven door open to prevent the device from being re-started accidentally.
Exterior housing
Clean the exterior surfaces of the device with a damp cloth.
Glass turntable, grill rack and rolling ring
The glass turntable, grill rack and rolling ring must be removed and cleaned
occasionally. Wash the glass turntable, grill rack in a warm soapy solution or in the
dishwasher.
The rolling ring should be cleaned regularly to prevent excessive noise development or
a rotational malfunctions. The rolling ring can be washed in a mild soapy solution or in
the dishwasher. Please remember to put the rolling ring back again properly after
cleaning it.
Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.
15 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
15.1 Safety notices
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
15.2 Causes and rectification of faults
The following table assists in localizing and rectifying minor faults.
Error
The selected program will
not start.
Please note
Attention
Attention
Device door is not closed
Power plug is not plugged in
Possible cause
Action
Close device door
Plug in mains plug!
61