OHAUS DEFENDER 3000 Serie Manual De Instrucciones página 5

DEFENDER 3000 Series Drum Scale
Positioning
Ensure the surface is flat in the area where the scale will be positioned, especially in the region of the load cell feet.
Small differences in height can be compensated by adjusting the load cell feet.
1. The Indicator is included with the Drum Scale. Ensure that it is kept with the Drum Scale during positioning
and protected along with the attached connecting cable.
2. Lower the scale base carefully onto to the floor in the final work area.
3. Check that the Drum Scale is level; check that the 4 feet are in contact with the ground; make adjustments
by rotating the nuts on the load cell feet or rotating the foot bolt head with slot with a screwdriver from the
top (see the figure below). Use an external level.
4. Ensure that the Drum Scale's cables do not become trapped or crushed during lifting or positioning.
Connecting an Indicator
Align the tab on the inside of the loadcell connector socket on the indicator to the slot on the loadcell cable
connector end. Insert the cable connector end into the indicator as shown below and then fasten it by rotating the
locking collar.
Caution: Pay attention on PINs when connect to the indicator, otherwise connector may be broken. Ensure that
the cable is protected against possible damage when routed to the indicator.
EN-3