Publicidad
Idiomas disponibles
Idiomas disponibles
EN
10
MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
10.1 CLEAN THE MACHINE
Keep the machine and the motor free of leaves,
branches or excessive oil to prevent fire risks.
•
Use a moist cloth with a mild detergent to clean the
machine.
•
Clean all moisture with a soft dry cloth.
•
Use a small brush to clean the air vents.
10.2 LUBRICATE THE BLADE
To increase the efficiency and life of the blades,
lubricate them carefully after each work session:
•
Put the machine on a flat and smooth surface.
•
Use a soft cloth to clean the blades and a brush to
remove more dirt.
•
Use a light layer of oil to lubricate the blades along
the top edge of the blade.
We recommend to use the non-pollutant type oil.
11
STORE THE MACHINE
Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged
components. If it is necessary, replace the damaged
components, tighten screws and bolts, or speak to a
person of an approved service center.
4. Store the machine in a cool and dry location.
CAUTION
CAUTION
WARNING
WARNING
NOTE
NOTE
English
12
TROUBLESHOOTING
Problem
The motor shuts
down whilst
working.
The machine
smokes during
operation.
The motor is on,
blades do not
move.
Too much noise
and/or vibration
is experienced
while working.
13
TECHNICAL DATA
Voltage
No load speed
Blade length
Cutting capacity
Weight (without battery
pack)
8
Possible cause
Solution
Make sure that
The battery pack
you tighlty instal-
is not installed
led the battery
tightly.
pack in the ma-
chine.
The battery pack
Charge the bat-
is out of power.
tery pack.
The machine
Do not use the
has damage.
machine and
speak to service
center.
1. Immediately
stop the ma-
chine.
The machine
2. Remove the
has damage.
battery.
3. Speak to
service cen-
ter.
Do not use the
The machine
machine and
has damage.
speak to service
center.
Remove battery
The blades are
then clear block-
blocked.
age from the
blades.
1. Stop the ma-
chine.
2. Remove the
battery.
The parts are
3. Inspect for
loosen.
damage.
4. Check and
tighten loose
parts.
Do not use the
The parts have
machine and
damage.
speak to service
center.
48V
3000 (±10%) SPM
20" (510 mm)
1.1" (27 mm)
8.8 lbs. (4 kg)
Publicidad
