Whirlpool WHAW050BW Manual De Uso Y Cuidado página 12

1.
Position air conditioner in window
A. Air conditioner
B. Side panel
C. Plastic frame
Using two or more people, place the air conditioner into the
window opening so the bottom of the air conditioner frame is
against the window sill.
2.
Close window
Sill
Make sure the bottom channel is seated over the window sill as
shown. Bring the window down temporarily behind the top angle
channel to hold the cabinet in place. Tilt the back of the unit
slightly downward to allow accumulated rain water to drain out.
3.
Secure cabinet
NOTE: If necessary, pre-drill holes in windowsill.
Fasten the cabinet to the windowsill using two 5/8" round-head
screws. Add the bottom channel seal over the screws. For 22,000
and 24,000 BTU models, the bottom channel seal should sit on a
gasket.
12
B
A
C
E
D
D. "I" section
E. Locking screw hole
Stool
angle
Install Support Brackets
NOTE: Attach curtains to the air conditioner before placing the air
conditioner in window.
1.
Mark bracket location
Hold each support bracket flush against the outside of the
window sill. Tighten each bracket to the bottom of the cabinet.
Mark the location of the brackets at the top level of the
windowsill. Remove the brackets.
2.
Assemble brackets
1/2" screw
5/8" flathead
bolt
Attach the sill angle brackets to the support brackets with 1/2"
screws, flat head bolts, and locknuts as shown. Hand tighten
screws loosely to accommodate changes that may be required
later in installation.
3.
Attach assembled brackets
Attach the support brackets (with sill angle brackets attached)
to the bottom of the cabinet with 1/2" screws and locknuts as
shown. Tighten all six bolts securely.
1/2"
locknuts
5/8" locknuts
Sill angle
bracket