Descargar Imprimir esta página

Whirlpool WHAW050BW Manual De Uso Y Cuidado página 20

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
Before calling for service, try the suggestions below to see whether you can solve your problem without outside help.
PROBLEM
The Air Conditioner Will
Not Start
The Air Conditioner Is
Not Cooling Properly
The Air Conditioner Is
Freezing Up
The Remote Control Is
Not Working
20
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
POSSIBLE CAUSES
The air conditioner is unplugged.
The fuse is blown/circuit breaker is tripped.
Power failure
The power cord reset button is tripped.
Airflow is restricted.
The temperature control is not set correctly.
The air filter is dirty.
The room is too warm.
Cold air is escaping.
The cooling coils are frozen.
Ice is blocking the airflow.
Batteries are inserted incorrectly.
Batteries are dead.
WARNING
RECOMMENDED SOLUTIONS
Make sure the power supply cord is plugged into a
grounded 3 prong outlet.
Check the house fuse/circuit breaker box and replace
the fuse or reset the breaker.
The unit will automatically restart when power is
restored. There is a protective time delay (approximately
3 minutes) to prevent tripping of the compressor
overload. The unit may not start normal cooling for
3 minutes after it is turned back on.
Press the reset button located on the power cord plug.
If the reset button will not stay engaged, discontinue
use of the air conditioner and contact a qualified service
technician.
Make sure there are no curtains, blinds, or furniture
blocking the front of the air conditioner.
Lower the set thermostat temperature.
Clean the filter. See the "Air Conditioner Care" section.
Allow time for the room to cool down after turning on the
air conditioner.
Close all open doors and/or windows where warm air
may be entering.
See "The Air Conditioner Is Freezing Up" below.
Turn off the unit and allow it to thaw until the ice has
melted, then operate on a higher fan speed. If this
continues to occur, contact customer service for
additional help.
Check that the batteries are inserted in the correct
direction.
Replace the batteries and dispose of them in a
responsible manner.

Publicidad

loading