Whirlpool WHAW050BW Manual De Uso Y Cuidado página 16

USING YOUR AIR CONDITIONER
SPEED
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
If you turn off the air conditioner, wait at least 3 minutes
■
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
Do not try to operate your air conditioner in the Cool mode
■
when outside temperature is below 65°F (18°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
Turning on the Air Conditioner
1. Press POWER to turn on air conditioner.
2. Press POWER again to turn off the air
conditioner.
Selecting the Mode
1. Press MODE to cycle through modes.
2. Choose Cool, Dry, or Fan.
Cool—Cools the room and reduces air
■
humidity. Press MODE to activate the cooling
function. Press the up or down arrow button
to adjust the temperature.
Dry Mode—Reduces the humidity of the air.
■
Press MODE to set the Dry mode. An automatic
function of alternating cooling cycles and air fan is
activated.
Fan—Only the fan runs. Press MODE to set the
■
Fan mode. Press FAN SPEED to select High, Med,
and Low. The remote control stores the speed set
in the previous mode of operation. In Auto mode,
the unit automatically chooses the fan speed and the mode of
operation (Cool, Dry, or Fan).
NOTE: After 5 seconds, display will show the current room
temperature.
16
MODE
MODE
Features
Eco—Conserves energy by turning off
■
compressor when room reaches desired
temperature. The fan motor will run for 10
minutes, stop for 20 seconds, then run again.
The compressor will turn back on when the room
temperature rises above the set temperature.
Press ECO to turn Eco feature on and off. When
the unit is in Eco mode, the light will turn on.
Sleep—Automatically adjusts the temperature
■
and fan speed to make the room more
comfortable during the night. Press and hold
the SLEEP button for 10 seconds until the sleep light turns
on. All of the left lights will turn off. The set temperature
will automatically raise by 1.8°F (1°C) every 30-60 minutes.
At most, the temperature will change six times until the
temperature reaches 82°F (28°C). Running time depends upon
the set temperature.
NOTE: After 5 seconds, display will show the current room
temperature.
Selecting the Fan Speed
1. Press FAN until the LED indicator for the desired setting is lit.
2. Choose Low, Med, or High.
Low—Low fan speed
■
Med—Normal fan speed
■
High—Maximum fan speed
■
NOTES:
Auto fan speed and temperature cannot be selected in Fan
■
Only mode.
In Eco and Sleep modes, Auto fan speed is selected
■
automatically.
After 5 seconds, the display will show the current room
■
temperature.
Adjusting the Temperature
Press the up arrow button to increase the
set temperature.
Press the down arrow button to decrease
the set temperature.
NOTE: After 5 seconds, the display on the
air conditioner control panel will show the
current room temperature.
SPEED