Publicidad
Idiomas disponibles
Idiomas disponibles
REMEMBER
to turn off the power. Follow
the steps below to hang your fan properly.
NOTE: For better fan performance, make
sure the mounting plate is level. Additional
washers (not included) may be needed to
insert between the outlet box and mounting
plate.
Attaching the fan to the
electrical box
1. Turn the power off.
2. Securely attach the mounting plate to the
outlet box using the two screws supplied
with the outlet box. Pull the 120-volt
supply wires (black, white and ground
wires) out of the outlet box and through
the hole in the mounting plate and lay
them to the side. (Figure 5)
Washers
Hanging the fan-motor
assembly
1. Carefully lift the fan-motor assembly and
engage the slot in the motor bracket on the
top of the fan-motor assembly with the
hook on the mounting plate so that it is
securely suspended. (Figure 6)
Then connect the wiring to your fan
according to step 5 "Making the Electrical
Connections" found on next page.
Motor
bracket
UL listed
electrical box
Mounting
plate
Fan-motor
assembly
Mounting
screws
Figure 5
2. Once the wiring is completed, lift the fan-
motor assembly.
3. Align the holes in the mounting plate
with the pre attached screws on the motor
bracket.
4. Securely tighten the screws.
Screw
Mounting plate
Hook
Fan-motor
assembly
Slot
Figure 6
4. Hanging the Fan
Mounting plate
Screw
Motor
bracket
Figure 7
Publicidad
