B
Product usage
All modes
/
Bluetooth/SD card/
USB
FM
NOTE: In AUX IN mode, you can change the volume level on the speaker. Use the
external device's controls for other playback functions.
WARNIING!: To protect your hearing, avoid listening to the speaker at full volume
for long periods of time.
FM Radio
The radio has a built-in antenna.
•
Press and hold the
•
Press the
button to select "FM radio". A melody will play.
•
Press the
button to automatically scan and save FM radio stations. The speaker will
stop searching when it has found all the available stations.
•
Press and hold the
NOTE: If the speaker cannot find any radio stations, try moving it to a different
location where it can receive a better FM radio signal.
Connecting two speakers (TWS)
Two EDENWOOD TUB1 speakers can be connected to an external audio device. This function
only works in Bluetooth or AUX IN mode.
1.
Make sure that both speakers are not connected to any other Bluetooth devices.
2.
Place the speakers within 10 metres of one another (without obstructions).
3.
Turn on both speakers. The blue LED lights will flash quickly.
4.
In Bluetooth mode, press and hold the
master speaker). The speaker will play a melody to confirm that it is looking for the other
speaker. Another melody will play on both speakers to confirm that they are connected
in TWS mode.
5.
Connect the external Bluetooth device through its Bluetooth settings to the speakers.
Choose the pairing name of the master speaker. When connected, the blue LED light
will flash.
6.
Press and hold the
will play to confirm the units are disconnected.
Press to increase the volume.
NOTE: A beep will sound when you reach the
highest volume setting.
Press and hold to skip to the next track.
Press and hold to skip to the next FM radio
station.
button to turn on the speaker.
or
button to select and listen to a radio station.
button on one of the speakers (this will be the
button on either speaker to stop using the TWS mode. A melody
25
EN