Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION REQUIREMENTS
Location of Your Washer
Do Not Install The Washer:
In an area exposed to dripping water or outside weather conditions.
1.
The ambient temperature should never be below 60°F (15.6 ℃) for
proper washer operation.
2. In an area where it will come in contact with curtains or drapes.
3. On carpet. The floor MUST be a hard surface with a maximum slope
of
" per foot (1.27 cm per 30 cm). To make sure the washer does not
1/2
vibrate or move, you may have to reinforce the floor.
NOTE: If floor is in poor condition, use
solidly attached to the existing floor covering.
IMPORTANT: MINIMUM INSTALLATION CLEARANCES
• When installed in alcove: Top and Sides = 0" (0 cm), Back = 3" (7.6 cm)
• When installed in closet: Top and Sides = 0" (0 cm), Front = 2" (5 cm),
Back = 3" (7.6 cm)
• Closet door ventilation openings required: 2 louvers each 60 square in.
(387 cm), located 3" (7.6 cm) from top and bottom of door
Electrical Requirements
Read these instructions completely and carefully.
！
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK AND PERSONAL
INJURY:
•
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG
WITH THIS APPLIANCE. Washer must be electrically grounded in
accordance with local codes and ordinances.
CIRCUIT - Individual, properly polarized and grounded 16-amp branch
circuit fused with 16-amp time -delay fuse or circuit breaker.
POWER SUPPLY - 2-wire with ground, 220-240V~, single-phase, 50Hz,
alternating current.
OUTLET RECEPTACLE - Properly grounded receptacle located so the
power supply cord is accessible when the washer is in an installed
position.
" impregnated plywood sheet
3/4
6
V .1
Publicidad
