Publicidad
Idiomas disponibles
Idiomas disponibles
In the case of lock screen, tap any button to light up the screen. After lighting the
screen, press and hold the timer button for 3 seconds to unlock.
If no operation for 30 seconds, the monitor automatically exits to the main interface
and locks the screen.
NOTE:
1)
The timer 'ON' and timer 'OFF' functions can be set at the same time.
2) The timer settings are repeating.
3) The timer settings are still valid after a sudden power cut.
5．
button
- When the screen is unlocked,
1) Short press
-- AUTO Mode (heat pump +E-heater)
-- GREEN Mode (only heat pump will work at normal working situation)
-- Boost Mode (heat pump +E-heater work at the same time)
-- E-heater Mode (only E-heater will work)
-- Ventilation mode (only fans work)
2) Check the system parameters
-Press this button and hold for 3 seconds, entry the system parameter checking
interface.
-Press the
3) Adjust the system parameters
- Press
for 3 seconds, entry the parameter checking interface.
- Press
or
ed), and then press
- Press the
to confirm the setting.
If no operation for 30 seconds, the controller will exit and save the setting auto-
matically.
NOTE: The parameters have been set; the user cannot change the parameters optionally.
Please ask a qualified service person to do this when required.
6． Error codes
During standby or running status, if there is a malfunction, the unit will stop auto-
matically and show the error code on the left screen of the controller.
, the mode can be adjusted operating mode
and
buttons to check the system parameters.
button to select the parameter (parameter A-F can't be adjust-
to confirm it.
and
buttons to adjust the selecting parameter, and then press
20
V.1
Publicidad
