Ampro TECSHOW NAVIGATOR 48 MKII Manual De Usuario página 12

2. Tap the Page button to select the correct page
the program you wish to run is located.
3. Push Master Slider B to its maximum position
(fully down).
4. Move the desired Channel slider (25-48) to its
maximum position to trigger the program, and
the program will fade in depending upon cur-
rent fade time. You may press and hold down
the relevant Flash button(25-48) to trigger the
program.
5. Move the Channel slider to adjust the output
of the current program.
P. 12
Tecshow Navigator 48 MKII |
English version
Running a Program To Audio
1. Use built-in microphone or plug the audio
source into the RCA Audio jack.
2. Select your program as described above.
3. Tap the Audio button until its LED lights, indi-
cating Audio mode is active.
4. Use the Audio Level slider to adjust the music
sensitivity.
5. To return to normal mode, tap the Audio button
a second time causing its LED goes out, the
Audio mode is disengaged.