35
36
Rear View
35. Power Switch - This switch controls turning on
or off of the power.
36. DC Input - DC 12-20V, 500 mA Min.
37. MIDI Thru/Out/In - MIDI ports for connection to
a sequencer or MIDI device.
38. DMX Out - This connector sends your DMX value
4. OPERATION GUIDE
Begin Programming
Record Enable
1. Press and hold down the Record button.
2. While holding down the Record button, tap the
Flash buttons 1, 6, 6 and 8 in sequence.
3. Release the Record button, the Record LED
lights up, now you can begin programming your
chase patterns.
P. 6
Tecshow Navigator 48 MKII | English version
37
38
39 40 41
to the DMX fixture or DMX pack.
39. Audio Input - This jack accepts a line level au-
dio input signal ranged from 100mV to 1Vpp.
40. Remote Input - Black Out and Full On may be
controlled by a remote control using a standard
1/4"stereo jack.
41. Fog Machine Connector
Note: The first time you turn on your unit, the
default setting of the Record Code is Flash buttons
1, 6, 6 and 8. You may change the Record Code to
protect your programs.