Ampro TECSHOW NAVIGATOR 48 MKII Manual De Usuario página 7

Security for Your Programs
To protect your programs from any editing by oth-
ers, you may change the Record Code.
1. Enter current Record Code (Flash buttons 1, 6, 6
and 8).
2. Press and hold down the Record and Edit but-
tons at a time.
3. While holding the Record and Edit buttons, tap
the desired Flash button to enter a new Record
Code The Record Code consists of 4 Flash but-
tons (the same button or different buttons), be
sure your new Record Code consists of 4 Flash
buttons.
4. Enter your new Record Code a second time, all
channel LEDs and scene LEDs will flash three
times, now the Record Code is changed.
5. Exit Record mode. Tap the Rec Exit button while
pressing and holding down the Record button,
release the two buttons at a time, the Record
mode is disengaged.
Important: Always remember to exit Record mode
when you won't continue your programming, other-
wise you may lose control of your unit.
Note: The second time you enter your new Record
Code different from that of the first time, the LEDs
will not flash, which means you've failed to change
the Record Code.
When you've entered a new Record Code the first
time, and now you want to cancel the new Record
Code, you may press and hold down the Record
and Exit buttons at a time to exit.
Program Scenes
1. Record Enable.
2. Select the 1-48 Single mode by tapping the
the Mode Select button. This will give you con-
trol of all 48 channels as you program.
Be sure that Master A & B are both set at maximum.
(Master A is at its maximum in the fully up position,
while Master B is at its maximum in the fully down
position.)
3. Create a desired scene using Channel Sliders
1-48. At 0% or DMX 0, these sliders should be
at 0 position, and at 100% or DMX 255, these
sliders should be at 10 position.
4. Once the scene is satisfactory, tap the Record
button to program the scene as a step into the
memory.
| Tecshow Navigator 48 MKII
English version
P. 7