Ampro TECSHOW NAVIGATOR 48 MKII Manual De Usuario página 16

Sending MIDI File Dump
Tap the Flash button 4 three times while holding
down the Record button, the Segment Display
reads "OUT" indicating the controller is ready to
send a file.
Note: During file dump, all other operations will not
function. Functions will automatically return when
the file dump is completed.
1. File dump will be interrupted and stop if errors
occur or power failure.
Implementation
1. During receiving and sending MIDI data, all MIDI
scenes and channels being run will automati-
cally paused if there is no response within 10
minutes.
2. During receiving and sending file dump, the
controller will automatically search for or send
Device ID of 55H(85), a file named DC2448 with
an extension of "BIN(SPACE)".
P. 16
Tecshow Navigator 48 MKII | English version
3. File dump allows this controller to send its MIDI
data to next unit or other MIDI devices.
4. There are two types of file dump mode de-
scribed as below:
Open Loop Mode
CONTROLLER
MIDI OUT MIDI IN
Close Loop Mode
CONTROLLER
MIDI OUT MIDI IN
5. The controller will send and receive Note On
and Note Off data via the Flash buttons.
Note No. Velocity
22-69 48 Program
master
70-117 48 Channel
intensity
118
119
120
121
122
123
124
125
126
RECEIVER
MIDI OUT MIDI IN
RECEIVER
MIDI OUT MIDI IN
Functions
turn on or off
program 1-48
Activate Channel
1-48
Full-On
Dark
Hold
Turn on or off
AUDIO
CHNS ◀▶ SCENES
Double Preset Mode
Single Preset Mode
Step
Black Out