Troy-Bilt 41CDZ25C766 Manual Del Operador página 15

5. Push the attachment straight into the coupler (Fig. 6) until the release button snaps firmly into the
primary hole (Fig. 7).
6. Turn the knob clockwise to tighten the coupler (Fig. 5).
WARNING:
into the primary hole and the knob is securely tightened.
WARNING:
the primary hole only. Using the wrong hole could lead to personal injury or damage to the
unit.
Removing the Attachment
1. Set the unit on a flat, level surface.
2. Turn the knob counterclockwise to loosen the coupler (Fig. 5).
3. Press and hold the release button (Fig. 7).
4. Pull the attachment straight out of the coupler (Fig. 6).
Tighten
Before operating the unit, make sure the release button is fully snapped
Unless specified otherwise, the release button should be snapped into
Coupler
Loosen
Fig. 5
Attachment
Fig. 6
15
Knob