Troy-Bilt 41CDZ25C766 Manual Del Operador página 16

INSTALLING AND ADJUSTING THE HANDLE
(Handle Type A or B)
Installing the Handle
1. Push the handle down onto the upper shaft housing (Fig. 8 or Fig. 9). Make sure the bolt hole faces
to the right (Fig. 8 or Fig. 9).
2. Insert the bolt into the bolt hole and push it through (Fig. 8 or Fig. 9). Tighten the bolt with a flat-
head screwdriver, but do not tighten the bolt completely .
3. Hold the unit in the operating position (Fig. 14). Move the handle up or down the upper shaft
housing to a comfortable location (Fig. 8 or Fig. 9). Make sure the handle is positioned beyond the
end of the safety label (Fig. 8 or Fig. 9).
4. Tighten the bolt with a flat-head screwdriver until the handle is secure.
Adjusting the Handle
If the handle requires adjustment:
1. Loosen the bolt with a flat-head screwdriver (Fig. 8 or Fig. 9).
2. Hold the unit in the operating position (Fig. 14). Move the handle up or down the upper shaft
housing to a comfortable location (Fig. 8 or Fig. 9). Make sure the handle is positioned beyond the
end of the safety label (Fig. 8 or Fig. 9).
3. Tighten the bolt with a flat-head screwdriver until the handle is secure.
A
Safety Label
Primary Hole
Bolt Hole
Bolt
Release Button
Guide Recess
Fig. 7
Fig. 8
16
Handle
Upper Shaft
Housing