Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION:
to the gasoline and oil mixing instructions on the 2-cycle oil container. Using improperly
mixed fuel can severely damage the engine.
Thoroughly mix the proper ratio of unleaded gasoline with 2-cycle engine oil. Do not mix them directly
in the unit's fuel tank. Use a separate fuel can. Use a 40:1 gasoline/oil ratio. See the table below for
specific gasoline and oil mixing ratios.
FUELING THE UNIT
WARNING:
stop the engine and allow it to cool before filling the fuel tank. Do not smoke while filling
the tank. Keep sparks and open flames at a distance from the area.
WARNING:
the unit without the fuel cap securely in place.
WARNING:
immediately. Avoid creating a source of ignition for spilled fuel. Do not start the engine
until fuel vapors dissipate.
1. Position the unit with the fuel cap facing up.
2. Slowly remove the fuel cap.
3. Place the fuel container spout into the fuel tank fill hole and fill the tank.
NOTE: DO NOT overfill the tank.
4. Wipe up any fuel that may have spilled.
5. Reinstall the fuel cap.
6. Move the unit at least 30 ft. (9.1 m) from the fuel container and the fueling site before starting the
engine.
For proper engine operation and maximum reliability, pay strict attention
Unleaded gasoline
1 gallon U.S.
(3.8 liters)
1 liter
MIXING RATIO - 40:1
Gasoline is extremely flammable. Ignited vapors may explode. Always
Remove the fuel cap slowly to avoid injury from fuel spray. Never operate
Add fuel in a clean, well-ventilated outdoor area. Wipe up any spilled fuel
2-cycle oil
3.2 fl. oz.
(95 ml)
25 ml
18
Publicidad
