Publicidad
Idiomas disponibles
Idiomas disponibles
Dimensions mm (in)
1 -
Overall height - 74 mm (2.91")
2 -
Overall width - 18 mm (0.71")
3 -
Top O-ring diameter - 14.58 mm (0.57")
4 -
Tip - 4.1 mm (0.16")
5 -
Bottom O-ring diameter - 12.83 mm (0.51")
Installation
Electrical
Pin 1: 12V to 24V switched power (never wire to constant power, this will damage the injector)
-
Pin 2: ECU injector output (Blue outputs)
-
Electrical with Peak and Hold
Use the Peak and Hold is mandatory when to use injectors in gray and yellow outputs. In this case its necessary
to install a Peak and Hold 8A/2A. See Peak and Hold manual's for more information.
Testing your injectors before first startup
-
Go to the outputs screen under the sensors and calibration menu in FTManager software
-
Setup each injector output, write map to ECU
-
Once the outputs are set, you can power the ECU up and click on the lightning bolt button near each injector output. The injectors will pulse when
the test button is pressed. Test each injector to ensure correct functionality, and to make sure they're on the correct cylinder and rail according
to your selection.
5
3
1
2
5
4
EN
Publicidad
