Mounting The Lens - Monacor TVCCD-624 Manual De Instrucciones

4 Lens
4.1 Adjusting the camera to the lens
Set the switches according to the lens typ used:
Lens type Lateral sliding
switch (6)
Video signal
position "VIDEO"
controlled AI lens
DC controlled AI lens position "DC"
Lens with fixed iris
any position
or manual iris control

4.2 Mounting the lens

Attention! Protect the CCD image sensor chip and
the lenses of the lens assembly against
dust and impurities; never touch them with
your fingers. If no lens is mounted, always
place the lens cover (1) on the lens mount
of the camera to protect the CCD image
sensor chip.
1) Remove the lens cover (1).
2) Release the setscrew (2) and adjust the rotating ring
(3) according to the lens type used:
DIP switch (9d) for
Then tighten the setscrew to lock the ring.
autom. electr.
shutter on/off
3) When using an AI lens (lens with automatic iris con-
trol), connect this lens to the jack "AUTO IRIS LENS"
position "OFF"
(4). Use the supplied plug, if required. The pin con-
figuration of the jack depends on the position of the
sliding switch (6):
position "OFF"
4
position "MIRIS"
3
Attention! Prior to connecting the lens, check the
when using a CS-mount lens, turn the ring clock-
wise (towards "CS") to the stop;
when using a C-mount lens, turn the ring counter-
clockwise (towards "C") to the stop.
2
1 jack "AUTO IRIS LENS"
Pin Position "DC"
1 damp -
2 damp +
3 drive +
4 drive -
position of the sliding switch (6) and the
pin configuration of the plug to prevent
damage to the camera or the lens.
Position "VIDEO"
power supply +12 V
output of video signal
ground
ground
GB
13