Publicidad
Idiomas disponibles
Idiomas disponibles
7
SERVICE
Turn off hot and cold water supplies
before beginning.
• To remove or replace cartidge.
- Turn valve to OFF position.
- Pull out PLUG BUTTON (1) and remove HANDLESCREW (2). Pull off HANDLE (3) and CAP (4).
- Unthread CARTRIDGE NUT (5) and remove. Pull out CARTEIDGE (6).
- Inspect CARTRIDGE (6) and O-RINGS (7) for debris and clean if necessary.
- Clean MANIFOLD (8) and rinse clean.
- Reinstall CARTRIDGE (6) and O-RINGS (7) onto MANIFLOD (8).
- Reinstall CARTRIDGE NUT (5), CAP (4) and HANDLE ASSEMBLY (3).
• If spout drips, operate handle several times from OFF to
ON and HOT to COLD position. Do not force - handles
turn only 90˚.
ADJUST HOT LIMIT SAFETY STOP
By restricting HANDLE rotation and limiting the
amount of hot water allowed to mix with the cold,
the HOT LIMIT SAFETY STOP (9) reduces risk of
accidental scalding. To lower the maximum hot
water temperature of your faucet, all you need to
do is adjust the setting on the HOT LIMIT
SAFETY STOP (9).
Note: The HOT LIMIT SAFETY
STOP (9)is set at the maximum
hot temperature setting from
the factory.
• To adjust HOT LIMIT SAFETY STOP:
- Remove HANDLE ASSEMBLY (3),
CAP (4) and CARTRIDGE NUT (5).
- Set the CARTRIDGE STEM (10) to the
OFF position and rotate it clockwise until
stops. Fig. B.
- Rotate the CARTRIDGE STEM (10) counter-clockwise
to a colder setting mark in the HOT LIMIT SAFETY
STOP (9). Fig. C.
- Lift up the HOT LIMIT SAFETY STOP (9) and rotate it to
coincide again with the stop in the base of the CARTRIDGE
STEM (10). Fig. D.
- Replace the HOT LIMIT SAFETY STOP (9).
- Reinstall CARTRIDGE NUT (5), CAP (4) and HANDLE
ASSEMBLY (3).
A
C
8
CARE INSTRUCTIONS
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL
CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS,
OR A CLOTH WITH A COARSE SURFACE.
9
5
4
1
2
+HOTTER
3
COLDER
9
10
10
7
6
8
9
SETTING
MARKS
A
9
10
GEAR
GEAR
9
B
GEAR
GEAR
C
D
Publicidad
