Publicidad
Idiomas disponibles
Idiomas disponibles
of drilling into or damaging gas or water
pipes or electricity cables in the position
where you are about to drill the holes. Use a
drill to drill the holes into the masonry.
Observe all safety instructions provided in
the operation and safety manual for your
drill. Otherwise there is a risk of serious or
fatal injury from electric shock.
Please note: The fixings included are
suitable for conventional solid masonry.
Please check independently what kind of
fixings are best suited for the surface on
which you intend to mount the light. If
necessary, you should seek the advice of an
expert.
What to consider when deciding on
where to mount the product:
Ensure the product illuminates the desired
„ „
area.
The motion sensor has a detection range
„ „
(field of view) of 1-10 m. Make sure that
the motion sensor covers the desired area.
The recommended installation height is 2 to
„ „
4 m�
If possible, mount the spotlight in a position
„ „
where it will not be exposed to dirt or dust
and is protected from rain and other
weathering effects.
Please note: The solar panel
positioned where it will be exposed to as
much direct sunlight as possible. Even partial
shade during the day can significantly
impair the charging process.
Orientation:
The optimum alignment is facing south.
Choose an orientation facing slightly to the
west rather than slightly to the east.
zMounting the spotlight
The spotlight can be mounted either on a
straight wall or on a corner using the wall
bracket (see Fig. C).
Please note: Make sure that you mount the
wall bracket the correct way round. Refer to
the arrows shown in Figure C for guidance.
With the wall bracket
„ „
mounting position, mark the positions for
the fixing holes on the wall using either the
guide holes
corner) or guide holes
straight wall) (see Figs. B and C).
Drill two holes (dia. 6mm) and insert the
„ „
matching wall plugs
Screw the wall bracket
„ „
or corner mounting) in place by inserting
the screws
the wall bracket is fixed firmly in place.
Slot the spotlight onto the wall bracket
„ „
from above (see Fig. D).
Please note: Make sure the product is firmly
attached!
zPositioning the spotlight
Tilt and turn the spotlight to the desired
„ „
position (see Fig. E). The spotlight can be
turned by up to 65° horizontally.
Please note: The product's beam width is
120°.
zPositioning the solar panel
should be
1
Tilt and turn the solar panel to the desired
„ „
position (see Fig. E). The solar panel can
be turned by up to 90° horizontally.
Orientation: Ideally, the product should be
oriented towards the south. An orientation
facing slightly to the west is preferable to
one slightly to the east.
Please note: To ensure perfect function,
make sure that the surface of the solar panel
is clean.
(for mounting on a building
5
7
through the guide holes
8
and firmly tightening them. Check that
6
GB/IE/NI/CY/MT
in its intended
4
(for mounting on
6
(see Fig. C).
(for straight-wall
4
/
5
4
59
Publicidad
