Publicidad
Idiomas disponibles
Idiomas disponibles
provide). The substrate to which the mounting bracket is to be attached by means of the screws provided shall
be capable of supporting a load of at least 30 kg. The fan must not sway.
•
Do not connect the fan power supply to any dimmers, potentiometers, wall switches or similar devices as this
may cause the fan to malfunction or damage its motor. It is essential that the electrical wiring includes a
circuit breaker in accordance with the Wiring Ordinance that will provide a single phase interrupt directly
connected to the domestic fuse and must have gaps between all conductors, which will provide total
disconnection under Category II surge conditions. The fan shall be connected to a protected circuit. Use only
the supplied remote control to turn the fan off and on.
•
Do not insert any objects into the blade rotation area that could be struck by the blades. Such an impact may
damage the blades and cause the fan to become unbalanced and cause vibration and increased noise.
•
After installation, check the tightness of the individual screws. Loose screws are one of the causes of a noisy
fan.
•
Due to the rotational movement of the fan, some connections may loosen over time. Therefore, check all
screws and other connections at least twice a year and tighten if necessary.
•
If the supply cable is damaged, it must be replaced by the manufacturer, a specialized service center or other
qualified certified service provider to prevent possible malfunctions or health hazards.
•
Replacement of the lighting of this fan must only be carried out by the manufacturer, a specialist service
centre or other qualified certified service centre to avoid any possible malfunction or danger to health.
Note: The important warnings and instructions in this manual do not cover all possible conditions and situations that may occur. You
should always use common sense, use caution, and anticipate possible situations that may arise.
Use the device according to the specified voltage.
The fan is intended for indoor household use only. Do not use it for other purposes.
Do not place the fan near heat generating equipment or near flammable or hazardous materials.
Installation
1.
Disconnect the power supply. This will prevent the risk of electric shock. Secure the supplied mounting bracket
to a suitable location on the ceiling or wall using the dowels and screws provided.
2.
Connect the wires from the domestic circuit to the corresponding wires coming from the fan.
3.
Use the screws to secure the fan body to the anchored bracket. Make sure the wires are not pinched in any way.
4.
Check that all screws are tightened securely.
5.
Restore the power supply. The fan is ready for use.
Remote control
Switching the light on/off
Colour temperature -
Color Temperature Change
(Neutral White/Cold White/Warm
White)
Night light
Wind deflector (not for this type of
model)
Timer 2/4 hours
Natural breeze
Total shutdown
Brightness +
Colour temperature +
Brightness -
Changing the direction of
rotation
Changing speeds 1-6
Switching off the fan
16
EN
Publicidad
