Noaton 15050 Furud Instrucciones De Uso página 17

The remote control requires no special pairing and can be used as soon as the fan is installed.
Due to the nature of the infrared signal, the fan to be controlled should ideally be within 4 m of the remote control,
longer distances can cause signal attenuation and possible loss. It is also necessary to ensure that there are no obstacles
between the controller and the fan and that the controller points its upper end (here the IR diode) directly at the fan.
This is the only way to ensure smooth operation and maximum user experience with this fan.
Correct placement

The fan blows a cone of air directly underneath itself and continues to drive it along the floor. So
use this information to choose the best place for the fan, taking into account its function as
ceiling lighting.

The input voltage parameters must correspond to the technical label on the device.

Make sure that there are no obstacles in the vicinity of the fan that could prevent proper airflow
or that could hit the unit (e.g. top cabinet doors, etc.).
Product maintenance
Before performing any maintenance, turn off the fan and disconnect the power supply (ideally by unplugging it at the
domestic fuse box). Clean the surface of the unit with a soft damp cloth.
Warning:

Do not immerse the fan in water

Do not use chemicals such as detergents, alcohol, thinners or abrasives for cleaning

Prevent any water from entering the device, especially on electronic components. There is a risk of
electric shock or damage to the instrument.
Cleaning and maintenance
The natural running of the fan causes the screws to gradually loosen. Check their tightening at least twice a year.
Clean the fan regularly to maintain its original appearance. Do not use water for cleaning, as it may damage the motor or
the materials of which it is composed, or even cause an electric shock. Use only a soft-bristled brush or microfiber cloth to
avoid scratching the surface.
Note: failure to follow maintenance instructions puts you at risk of losing your warranty claim.
Disposal
This product is not ordinary waste. To dispose of the product, use your local recycling system or
contact the retailer from whom you purchased the product. Do not dispose of the product with
regular household waste. Using the correct disposal method will help protect the environment.
Assurance of conformity
Manufacturer: Gavri s.r.o.
Model: Furud
This product has been declared to comply with the requirements and other relevant provisions of Directive
2014/30/EU on electromagnetic compatibility and Directive 2014/35/EU on low voltage and all other relevant
requirements of the EU Directive. The Declaration of Conformity has been issued under our responsibility and
is available on request.
17
EN