Metabo HPT DH 26PC Manual De Instrucciones E Instrucciones De Seguridad página 10

English
2. Rotation + Hammering
This rotary hammer can be set to rotation and
hammering mode by pressing the push button and
turning the change lever to
Fig. 7
(1) Mount the drill bit.
(2) Pull the trigger switch after applying the drill bit tip to
the drilling position (Fig. 8)
Fig. 8
(3) Pushing the rotary hammer forcibly is not necessary
at all. Pushing slightly so that drill dust comes out
gradually is just su cient.
CAUTION
When the drill bit touches an iron reinforcing
rod, the bit will stop immediately and the rotary
hammer will react to revolve. Therefore please grip
the side handle and handle tightly as shown in Fig.
8.
3. Rotation only
This rotary hammer can be set to rotation only mode
by pressing the push button and turning the change
lever to mark. (Fig. 9)
Push button
Fig. 9
10
000Book_DH26PC_NA_metabo.indb 10 000Book_DH26PC_NA_metabo.indb 10
mark. (Fig. 7)
Push button
Change lever
Change lever
To drill a wood or metal material using the separately
sold drill chuck and chuck adaptor, proceed as follows.
Installing drill chuck and chuck adaptor (Fig. 10):
Front cap
Drill chuck
Part of SDS-plus
shank
Chuck adaptor
Fig. 10
(1) Attach the drill chuck to the chuck adaptor.
(2) The part of the SDS-plus shank is the same as the drill
bit. Therefore, refer to the item of "Mounting the drill bit"
for attaching it.
CAUTION
Application of force more than necessary will not
only reducing drilling e ciency at all, but will
deteriorate the tip edge of the drill bit and reduce
the service life of the rotary hammer in addition.
Drill bit may snap o while withdrawing the rotary
hammer from the drilled hole. For withdrawing, it
is important to use a pushing motion.
Do not attempt to drill anchor holes or holes in
concrete with the main unit in the rotation only
function.
Do not attempt to use the rotary hammer in the
rotation and striking function with the drill chuck
and chuck adaptor attached. This would seriously
shorten the service life of every components of the
machine.
4. When driving machine screws (Fig. 11)
First, insert the bit into the socket in the end of chuck
adaptor (D).
Next, mount chuck adaptor (D) on the main unit using
procedures described in 6 (1), (2), (3), of "PRIOR TO
OPERATION", put the tip of the bit in the slots in the
head of the screw, grasp the main unit and tighten the
screw.
Bit
Socket
Chuck adaptor (D)
Fig. 11
Grip
Front cap
Grip
2018/03/22 9:55:31 2018/03/22 9:55:31